Electric radiant floor heating reviews
heated bathroom floor
Radiant floor heating by 15-20 percent more economical cable system. First of the main advantages of this floor is that it is suitable for any type of coating.
If you want a warm floor under the carpet, laminate or tile, the electric radiant floor heating is what you are looking for. But before you put a warm floor under a particular coverage, consult with experts. Because under the same coverage area, you can use different amounts of infrared film.
Let's take a closer look at the very infrared heating film.
First, define what constitutes a set.
Electric radiant floor heating reviews
Bathroom floor heating, the problem of wave doable for anyone who can read the instructions carefully.
Before you buy a radiant floor heating, calculate how much film you need to heat. The electric radiant floor heating should be laid at the spot where there is no furniture. This will help you save time and money.
First, clean up the floor from dust and dirt, and then put back insulation material. If you will lie on top carpet, then you should lay insulation thickness of which must be from three to five mm. If you decide to put the tiles on the floor, you'd better use of insulation with a solid layer. Perfect technical cork, the thickness of which will be two mm.
Insulation should be laid around the perimeter, and glue the joints with tape.
Then draw a wall where the thermostat will be located.
Next, cut the infrared film on the band of the size you want. Cut the need for special lines cut. After that, place the strips on the floor, a copper strip down. Contact the side wall on which the regulator will be installed temperature sensor. Thereafter, a copper strip of infrared film is set clamp. To connect the terminal connecting wires.
After that, connect the floor sensor on the back of infrared film and isolate it.
That's almost all, now we have to connect the wires and mounting the temperature sensor to the thermostat, and the thermostat switch on the electricity supply. Then perform the test (we heat our floor to 30 degrees). Check the contact and the lack of heat in the joints. After that …the top coat.
Good luck to you repairs! :)
bathroom sink plumbing repair
bathroom sink plumbing repair
